Thermo King 088669, Руководство пользователя

Страница: 112 / 136

Structural Maintenance (Rev. 04/03)
98
Installing Oil Seal
4. Place the shaft in the housing. Install a new seal in the
retainer cap. Use the original shims and replace the O-
ring if necessary.
Shims and O-ring
5. Install the retainer cap assembly over the shaft, and
then install the bolts.
6. Torque the bolts in a criss-cross pattern in equal steps to
80 in-lbs (9.04 N•m).
Torquing Retainer Plate Bolts
7. Lock the assembly in a vise and set up a dial indicator
to read the end play. To measure the end play, rotate the
shaft while pushing in one direction, and set the dial
indicator to 0. Now rotate the shaft and pull in the
opposite direction while reading the dial indicator. The
end play should be .001 to .005 in. (0.025 to 0.127
mm). If the end play is incorrect, use different shims to
obtain the correct end play.
Shims available from the Service Parts Department:
.020 in. (0.500 mm) P/N 99-4231
.007 in. (0.177 mm) P/N 99-2902
.005 in. (0.127 mm) P/N 99-2901