Thermo King 088669, Руководство пользователя

Страница: 111 / 136

Structural Maintenance (Rev. 04/03)
97
6. After all the parts are cleaned, inspect the bearings and
bearing races for wear or damage.
7. To replace the bearings, first remove the roll pin that is
in the center of the shaft.
Removing Roll Pin
8. With the roll pin removed, place a pipe over the shaft
and drive one bearing down until the opposite bearing
and bearing spacer release from the shaft.
9. After removing one bearing and the bearing spacer,
turn the shaft upside down and drive the other bearing
off, using the pipe.
10. The bearing races can now be driven out with a punch
and replaced in the same manner.
Reassembly
1. Install the new bearings on the shaft with a pipe in the
same way they were removed.
Installing Bearings
2. When replacing the bearing race on the evaporator end
of the assembly, the splash guard will come out with the
race. Reinstall the splash guard after replacing the bear-
ing race.
Installing Splash Guard
3. Install a new oil seal after replacing the bearing race
and splash guard.