Thermia Atria Optimum, Руководство по установке

Страница: 10 / 76

3 Transport, unpacking and setting-up
3.1 Transporting the heat pump
Caution
During transportation or lifting of the entire heat pump, the front panel must always be installed as it locks
the other panels construction.
Caution The heat pump must always be transported and stored in a dry area. Secure the heat pump so that it cannot
tip over during transportation.
Caution
The heat pump must always be transported and stored standing and in a dry environment. If the heat pump is
laid on the incorrect side it may become seriously damaged as the oil in the compressor can run out in the
pressure pipe and therefore prevent normal function.
When transporting indoors to the installation location it may be necessary to place the heat pump on its back. The time that the heat
pump is transported on its back should be as short as possible. After the heat pump has been lifted up again it must stand upright for at
least an hour before commissioning.
3.2 Unpacking
3.2.1 Unpack the heat pump
1. Check that there is no transport damage.
2. Remove the packaging.
3.2.2 Delivery check
1. Check that the delivery contains the following components:
4-10 kW 12-13 kW 16-17 kW
Safety valve 9 bar ½" 1 1 1
Safety valve 1,5 bar ½" or 3 bar 1/2'' 1 1 1
Outdoor sensor 1 1 1
Expansion and bleed tank or Expansion vessel with manometer 1 1 1
Rubber bellows for 22-28 mm hole 5 5 5
Rubber hose R20 L=550 2 - -
Rubber hose R25 L=550 - 2 2
Filling device DN25 1 1 -
Filling device DN32 - - 1
Dirt strainer with shut off valve DN20 1 - -
Dirt strainer with shut off valve DN25 - 1 1
Manual holder 1 1 1
Installation Guide Domestic heat pumps
VMGFP202 Thermia Värmepumpar
10