Thermann 26LP50C, Руководство по установке

Страница: 6 / 28

Thermann Installer's Manual
Gas Continuous Flow Condensing Water Heaters
6
GENERAL
The Thermann Continuous Flow must be installed in accordance with the following:
(1) These instructions;
(2) National Construction Code and Local authority regulations;
(3) AS/NZS 3500.4 “Plumbing and Drainage - Heated Water Services”,
(4) The Australian standard for gas installations AS/NZS 5601;
(5) Any other statutory regulation that may apply;
(6) A notice of intention to install shall be lodged with the relevant local Gas Authority
prior to installation.
DELIVERY INSPECTION
The Thermann Gas Continuous Flow hot water heater unit is supplied fully assembled and
ready for installation.
The installer, upon delivery of the unit, should immediately remove all packing materials
and inspect the unit for damage, and ensure that the unit supplied is correct for the
gas supply to which it is to be connected. If any concerns, please report any damage or
discrepancies to Reece, quoting the serial number and model number, which can be found
on the outside of the cabinet.
INSTALLATION MUST BE CARRIED OUT ONLY BY AN AUTHORISED AND
APPROPRIATELY LICENSED PERSON.
This product is an external electronic gas hot water heater.
These units are factory set to deliver 50°C or 60°C depending on the model purchased.
If the unit has a factory setting temperature higher than 50°C and is intended to deliver
water directly to sanitary fixtures used primarily for the purposes of personal hygiene,
it must be fitted with an approved tempering valve into the hot water piping to any
bathroom and/or ensuite.
Up to three optional remote controllers can be provided for complete hot water
temperature selection. If this option is used an approved temperature limiting device
must be installed on any units with a delivery temperature above 50°C.
INTRODUCTION
THIS HOT WATER UNIT IS NOT FOR POOL OR SPA HEATING