Thermann 26LP50C, Руководство по установке

Страница: 15 / 28

15 15 15
REMOTE CONTROLLERS
L S M S M S
180mm
270mm
KNOT
KNOT
180mm
KNOT
180mm
KNOT
KNOT
270mm
KNOT
270mm
KNOT
KNOT
3. CONNECTION OF CABLE TO THE THERMANN UNIT
1. Remove the front cover from the unit.
2. Install the cable to the Thermann main unit using conduit or by concealing the cables
in the wall cavity.
3. Install the cable into the cabinet through the conduit in accordance with the table below.
4. Based on “How to fix the cables”, attach the cable to the plate adjacent to the terminal block,
using the cable clamp provided.
5. Attach the cables to the terminals for the remote controllers.
6. Replace the front cover of the water heater.
How to fix the cables (Remote controller cable(s) and cascade cable)
Number of cable
How to tie the
cable(s) at the
power cable
entry
Required cable clamp
How to fix the
cable(s)
The length
between the knot
and the cable
terminal
How to connect
the cable(s) to
the terminal
1 2 3 4*
Make a knot Tie two cables
Tie two cables and
make a knot on the
rest cable
Tie the cables
two by two
Clamp (small) Clamp (medium)
1 cable:clamp (small)
2 cables:clamp (medium)
1 cable:clamp (small)
3 cables:clamp (large)
180mm 180mm
1 cable:270mm
2 cables:180mm
2 cables:270mm
2 cables:180mm
Attach the cable to
underside of terminal
Attach the cables to
underside of terminal
Attach the cable(180mm)
to underside of terminal
Attach the cables(270mm)
to upperside of terminal
Attach the cables(180mm)
to underside of terminal
Attach the cables(270mm)
to upperside of terminal
* Up to three remote controller can be installed. In this case, three remote controller cables and one cascade cable shall be connected.
4. HOW TO FIX THE CABLES (REMOTE CONTROLLER CABLE(S) AND
CASCADE CABLE)
*Up to three remote controllers can be installed. In this case, three remote controller cables
and one cascade cable is being connected.