Thermal Dynamics DRAG-GUN 38, Инструкция по эксплуатации

Страница: 46 / 60

SECTION 5: SERVICE 40 Manual 0-2729
P. Starting Capacitor Replacement
1. Remove top Panel Cover per paragraph 'E' above.
2. Locate the Starting Capacitor attached to the base of
the unit, near the Compressor.
3. Remove two wires connected to the Starting Capaci-
tor.
4. Remove tie wrap securing Capacitor wires to wire
harness.
5. Loosen the Clamp which secures the Starting Ca-
pacitor in place inside the bracket on the base of
unit.
6. Remove Starting Capacitor from unit.
7. Install replacement Capacitor by reversing steps 1-
6, reconnecting wires as shown below:
Plain Wire Striped Wire
A-02575
Compressor Side
Figure 5-23 Starting Capacitor Wiring
5.12 Torch and Leads Replacement
Procedure
1. Remove right panel of Power Supply per paragraph
'D' above.
2. Locate the Torch Block.
Torch Block
Area
A-02129
Nylon Screw
Figure 5-24 Torch Block Location
NOTE
All wires are outside the protective insulating sheet.
3. Remove the nylon screw holding the protective in-
sulating sheet to the Torch Block.
4. Loosen the torch lead strain relief nut inside the top
panel. Do not remove the strain relief from the leads.
Replacement torch leads are provided with strain
reliefs.
5. Disconnect the two pin torch switch connector
(white and black wires) and the red pilot wire (ter-
minal E14) from the Main PC Board Assembly side
connectors.