Thermal Dynamics DRAG-GUN 38, Инструкция по эксплуатации

Страница: 25 / 60

Manual 0-2729 19 SECTION 5: SERVICE
SECTION 5:
CUSTOMER/OPERATOR
SERVICE
5.01 Introduction
This section describes basic maintenance procedures
that can be performed by operating personnel, and
advanced procedures that can be performed by qualified
technicians. No other adjustments or repairs other than
those described are to be attempted.
WARNINGS
Disconnect primary power at the source before dis-
assembling the torch, torch leads, or power supply.
DO NOT touch any internal torch parts while the
AC indicator light on the front panel of the power
supply is ON.
Frequently review the Important Safety Precautions
at the front of this Manual. Be sure the operator is
equipped with proper gloves, clothing, eye and ear
protection. Make sure no part of the operator’s body
comes into contact with the workpiece while the torch
is activated.
CAUTION
Sparks from the cutting process can cause damage
to coated, painted, and other surfaces such as glass,
plastic and metal.
5.02 General Maintenance
A. Recommended Maintenance Schedule
NOTE
The actual frequency of maintenance may need to be
adjusted according to usage and the environment.
R e c o m m e n d e d R o u tin e M a in te n a n c e
S c h e d u le
D a ily O p e r a tio n a l C h e c k s o r E v e r y 6
C u ttin g H o u r s:
1 . C h e c k to rc h c o n su m a b le s. R e p la c e if
d a m a g e d .
2 . In sp e c t t or c h a n d le a d s fo r a n y c ra c k s
o r e x p o se d w ire s. R e p a ir o r re p la c e
b e fo re p ro c e e d in g .
3 . In sp e c t i n p ut p o w e r c a bl e f o r d a m a g e
o r e x p o se d w ire s. R e p a ir o r re p la c e
b e fo re p ro c e e d in g .
W e e k ly o r E v e r y 3 0 C u ttin g H o u r s:
1 . C h e c k fo r p ro p e r fa n o p e ra tio n .
2 . V a c u u m d u st a n d d irt o u t o f th e e n tir e
m a c h in e , in c lu d in g th e a ir filte r.
E v e r y T h r e e M o n th s:
1 . R e p la c e F ilte r D ry e r E le m e n t.
(S e e R e p la c e m e n t P ro c e d u re s)
E v e r y S ix M o n th s:
1 . R e p la c e C o m p re sso r A ir In ta k e F ilte r.
Figure 5-1 Routine Maintenance
B. Power Supply Cleaning
WARNINGS
Disconnect primary power at the source before dis-
assembling the torch, torch leads, or power supply.
CAUTION
When cleaning care must be taken not to move or
damage the electronic components.
To clean the unit, open the enclosure and use a vacuum
cleaner to remove any accumulated dirt and dust. The
unit should also be wiped clean. If necessary, solvents
that are recommended for cleaning electrical apparatus
may be used.