Thermal Arc 161 STL, Руководство по обслуживанию

Страница: 35 / 96

OPERATION THERMAL ARC 161STL, 201TS
Manual 0-5148 4-7 Operation
3. Connect the work clamp to your workpiece.
4. Plug the power cable into the appropriate outlet, and turn the switch to the “ON” position. The power L.E.D light
should illuminate.
5. Set the “Process Selection Switch” to STICK.
6. Set the weld current control knob to the desired amperage.
7. Set the ARC FORCE CONTROL knob to 2.
Minimum (0) provides a soft arc, low spatter & low penetration.
Medium (2) provides a normal arc, improved fusion & normal penetration.
Maximum (10) provides a hard arc & deep penetration.
8. Install a stick electrode in the electrode holder.
9. You are now ready to begin STICK Welding
NOTE
Gently strike the electrode on the work piece to generate a welding arc, and slowly move along the work
piece while holding a consistent arc length above base metal.
4.04 LIFT TIG (GTAW) Setup
Set Process Selection
Switch to LIFT TIG.
Positive Output
Terminal
(Dinse™ 50)
Negative
Output
Terminal
(Dinse™ 50)
Art # A-09785_AB
Set Welding Current
as specified by the
Electrode Manufacturer.
Secure the gas cylinder in an
upright position by chaining it
to a stationary support to prevent
falling or tipping.
Switch to 2T/4T
Set DOWN Slope
Figure 4-4: Setup for LIFT TIG (GTAW) Welding