Thermador DWHD860RFM, Инструкция по использованию и уходу

Страница: 35 / 84

35
Food soils on the dishes. Dishes placed too closely together,
racks overfilled.
Arrange dishes with adequate clearance
between them ensuring that the spray jets can
reach the surface of the dishes. Prevent con-
tact points.
Spray arm rotation obstructed. Arrange dishes so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles.
Filters 1b dirty.
Clean filters.
Filters
1b
inserted incorrectly and/
or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak. Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or Inten-
sive.
Tall narrow containers in corner
areas are not rinsed adequately.
Do not place hollow containers too obliquely
and do not place in the corner area.
Upper rack 12 on right and left
not set to same height.
Set upper rack to same height using side
levers.
Dishwasher seems to run a
long time
Incoming water is not warm enough. Before starting a cycle, run hot water faucet at
the sink closest to the dishwasher.
Cycle time can vary due to soil and
water conditions.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good wash
when heavy soil is detected.
Rinse aid dispenser
9*
is empty. Add rinse aid.
Dishwasher connected to cold
water supply.
Note: :
Check the typical wash cycle
length.
Verify dishwasher is connected to hot water
supply plumbing.
Detergent residue.
Detergent dispenser cover
92
blocked by dishes and therefore
does not open fully.
Dishes must not be placed above the deter-
gent tab tray 1B . These may block the lid of
the detergent dispenser and prevent it from
opening fully.
Do not place dishes or fragrance dispenser in
the detergent tab tray.
Detergent dispenser cover 92
blocked by the detergent tab.
Detergent tab must be inserted flat and not
upright.
Detergent tab used in the quick or
short wash cycle.
Dissolving time of the detergent is
not reached in the selected short
wash cycle.
Dissolving time of detergent tab too long for a
quick or short wash cycle.
Use a detergent powder or select a more
intensive wash cycle.
Washing effect and dissolving per-
formance are reduced after a pro-
longed storage time or detergent is
very lumpy.
Change detergent.
Water stains on plastic parts. Droplet formation on plastic sur-
face is physically unavoidable. After
drying, water stains are visible.
Use a more intensive wash cycle (more water
changes).
Arrange dishes in a sloping position.
Use rinse aid.
If required, increase softening setting.
Fault Cause Remedial action