Thermador DWHD860RFM, Инструкция по использованию и уходу

Страница: 34 / 84

34
A different error code is indi-
cated on the digital display.
(
“
:
‹‚
to
“
:
„‹
)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF switch
(
. After a short time restart the appliance.
If the problem recurs, turn off the tap and pull
out the mains plug.
Call customer service and mention the error
code.
Refill indicator for salt P
and/or rinse-aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt tablets. Use different special salt.
Refill indicator for salt P
and/or rinse-aid H is not lit.
Refill indicator switched off. Activation/deactivation.
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left in the appliance
at the end of the wash cycle.
Filter system or area under the fil-
ters 1b is blocked.
Clean filters and area underneath.
Wash cycle has not ended yet. Wait until wash cycle ends or reset.
Dishes not dry. No or too little rinse aid in the dis-
penser.
Refill rinse aid.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
Arrange dishes in a sloping position, arrange
affected dishes as sloping as possible.
The combined detergent used has a
poor drying performance
Use different combination detergent with better
drying performance. Use of rinse aid also
increases the drying performance.
extraDry to increase drying not acti-
vated.
Activate extraDry.
Dishes were removed too early or
drying process had not ended yet.
Wait until wash cycle ends or wait until 30 min
after wash cycle ends before removing dishes.
The eco rinse aid used has a limited
drying performance.
Use a proprietary rinse aid. Eco products may
have limited effectiveness.
Plastic dishes not dry. Special properties of plastic. Plastic has a lower heat storage capacity and
therefore dries less well.
Silverware not dry. Silverware not arranged properly in
the silverware basket.
Separate silverware if possible, prevent con-
tact points.
Silverware not arranged properly in
the third rack.
Arrange silverware properly and separate if
possible.
Appliance interior wet after
rinse cycle.
No appliance fault. On account of the “Condensation drying” prin-
ciple, water droplets are physically induced
and required in the container. The humidity in
the air condenses on the inner walls of the
dishwasher, drains and is pumped out.
Fault Cause Remedial action