Thermador DWHD860RFM, Инструкция по использованию и уходу

Страница: 31 / 84

31
Note:
Clean the filter after washing loads with large
amounts of food soils or loads with a heavy starch
content to maintain optimal performance.
To check or clean the filter system:
1.
After each wash cycle check the filters for residue.
2.
Unscrew the Large Object Trap as illustrated and
remove the entire filter system.
3.
Remove any residue and clean filters by rinsing under
running water.
Note:
do not use abrasive brushes or steel wool, etc.,
as they may damage the filter.
4.
Reinstall the filter system in reverse sequence and
lock into place by screwing the Large Object Trap until
the marking arrows align.
Spray arms
Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms
1:
and
1R
.
1.
Check outlet nozzles on the spray arms for blockages.
2.
Unscrew the upper spray arm
1:
(1) and remove
downwards (2).
3.
Remove the lower spray arm
1R
upwards.
4.
Clean spray arms under running water.
5.
Re-engage or screw on spray arms.
Drain pump
Large food remnants in the rinsing water not retained by
the filters may block the waste water pump. In this case:
9
WARNING
Use caution when removing parts for cleaning as
some debris may be sharp.
1.
Disconnect the appliance from the power supply.
2.
Take out upper rack 12 and lower rack 9" .
3.
Remove the filters
1b
.
4.
Scoop out standing water - use a sponge if necessary.
5.
Using a spoon, pry off the pump cover (as shown) until
it clicks, then grip the cover and pull upward until it
resists and then pull forward (1). Remove cover
completely.
Cleaning interval Use this setting,
3 times a year if you rinse before loading
4 times a year if you only scrape before loading
6 times a year if you do not rinse or scrape
before loading
12 times a year if you have hard water