16
Art. no.: A003-928_Rev 01
Last edited: CW40/2014
FEEDBACK SENSOR INCL. TOUCH KEY
USER MANUAL
8.2 Switching on/off the feedback sensor incl. touch key
To switch the feedback sensor incl. touch key on:
►
The battery must be charged.
►
Press the touch key until the activation/charge status indicator shows a
status.
The LED of the charge/activation status indicator lights up green.
The feedback sensor incl. touch key is trying to establish a connection with the
control and display unit.
►
The LED of the connection status indicator flashes green while the
connection with the control and display unit is being established.
►
When the LED of the connection status indicator lights up with a steady
green, a connection has been established.
To switch the feedback sensor incl. touch key off:
►
Press the touch key until the activation/charge status indicator doesn't show
the status.
The LED of the charge/activation status indicator will turn off.
8.3 Establishing a connection
After the feedback sensor incl. touch key has been switched on, a wireless
connection is established between the feedback sensor incl. touch key and the
control and display unit.
In order to establish a wireless connection, a Bluetooth receiver for the sensors
must be plugged into the control and display unit.
Only use the Bluetooth receiver
for sensors approved by the manufacturer (article no. A004-020).
If a different Bluetooth receiver is used, no wireless connection can be established.
The LED of the connection status indicator indicates the following status:
LED flashes green:
A connection is being established between the feedback sensor incl. touch
key and the control and display unit.
This can take several seconds.
If a connection cannot be established, the feedback sensor automatically
switches off after approx. 3 minutes.
► Check whether the feedback sensor incl. touch key is too far away from
the control and display unit.
- The wireless connection has a range of about 5 metres.
► Check whether the control and display unit is switched on.
► Check whether a Bluetooth receiver for sensors is plugged into the
control and display unit for the wireless connection.
► Check whether the correct Bluetooth receiver for sensors is plugged in
(article no. A004-020).
► Ensure the correct Bluetooth receiver for sensors is plugged in before
starting the THERA-Trainer software.
LED lights green:
A connection is being established between the feedback sensor incl. touch
key and the control and display unit.
Switching on
Switching off
Note
