9
theSenda P
theSenda S
Test detection area (walking test)
The walking test is used to test the detection area and to
restrict it if necessary.
Select ON in the app
▻
The detector always responds to movement (regardless
of brightness and confi guration type).
▻
After the detector has detected a movement, all con-
tacts switch on for 2 s.
▻
If motion is detected the red LED on the master lights
up.
theSenda B/app
theSenda P
L
The test mode ends after 10 min.
Restart
theSenda B/app
theSenda P
Factory settings
Parameter
theMura S180-101 UP
Brightness setpoint value A
500 lux
Room correction factor A
0.3
Detection sensitivity
3
Time delay A
10 min
Short presence A
On
Channel function H
On
Time delay H
10 min
Switch-on delay H
0 s
Confi guration type
Auto
Staircase light function
Off
Orientation light time delay
0 s
Orientation light brightness
80%
Extended function duration
4 h
Acoustic sensor sensitivity
Off
LED display motion
Off
Switch-on behaviour
Start-up phase (45 s) after restoration of power
▻ The red LED fl ashes at one second intervals, all switch
contacts are closed.
▻
The detector does not respond to push button com-
mands and remote control commands.
▻
When no one is present, all contacts open after 45 s.
Operation
▻
The detector is ready for operation (LED off).
LED display
LED
Description
Flashes at 1 second
intervals
The presence detector is in the start-up phase.
Flickers for 2 s
The command sent from the remote control via
infrared was accepted by the presence detector.
Lights up briefl y
The command sent from the remote control via
infrared was rejected by the presence detector.
The command is not valid. Check the selected
detector type or parameters in the app.
Flashes rapidly
Error fl ashing; the presence detector has found
an error.
Flickers for 20 s
Teach-in via potentiometer is activated.
Lights up or fl ickers
irregularly
The presence detector is in presence test mode
or "LED display movement" is activated. The LED
detects movements.
