21
22
23
24
06/20
Using a pencil, mark the holes where
the 90°glass to wall bracket will be
a�ached.
Using masking tape onto the wall to
mark your measurements.
Using a straight edge, mark where the
wall channel needs to be trimmed
above the glass panel.
To protect the channel finish, it is
recommended to mark on masking
tape.
Carefully seperate the two panels.
Leaving the brackets on the panels, li�
the glass out and put to one side.
Note and leave the spacers in the
base channels.
4mm
4mm
4mm
4mm
Carefully remove the wall channel and
trim using a fine toothed junior
hacksaw.
Use a fine file to remove any burrs.
Be careful not to damage the channel
finish.
VIEW 07
07/2019 V 2.2
