The Handy THCS-65, Руководство пользователя

Страница: 5 / 11

Page 6
ASSEMBLY, cont’d
Attach the axle brackets, axle and tyres referring to Fig 3 below :
• Remove the sturdy support.
• Remove the bolt and pipe spacer 6 and 7
• Put the rear axle brackets in place and align the mounting holes with holes 6 and 7.
• Refit the pipe spacer and the long bolt 7, and secure tightly with a washer and nut.
• Insert bolt M8x20 into hole 6 and secure tightly with locknut.
Attach the chipper tube to the machine referring to Fig 4 below :
• Remove the nuts and washers of the two top threaded studs and loosen the bottom
two nuts.
• Put the chipper tube 2 in place on the side by positioning the plate over the bottom
studs and securing the nuts on the top studs.
• Secure the flange with washers and nuts M8.
• Make sure the tube i s located at the correct angle and take care to locate the steel
flange on the chute into the aperture in the body . Finger tighten then tighten the nuts.
.
Fig 3
Fig 4