The Handy THCS-65, Руководство пользователя, Страница: 6 / 11

Page 7
ASSEMBLY, cont’d
Mounting the Frame:
• The steel frame can be used as a handle grip.
• Firstly attach the steel bar on both the left and right side of the hopper using screws.
• Put the frame on the bars and fix it by tightening the screws.
• Then tighten the screws on the hopper.
Finally check that all screws, bolts and nuts are securely tightened. Do this every time you
use the machine.
The chipper/shredder is supplied without fuel or oil.
Using the separate engine instructions as your guide, fill the oil tank with good quality
engine oil - SAE10W30 or SAE10W40. Check the level with the dipstick ensuring that it is
10-15mm from the top of the tank.
Fill the fuel tank with unleaded petrol - again do not fill closer than 10-15mm from the top
to allow for expansion.
Wheel the shredder to the work site and place a collection receptacle under the discharge
chute (or allow the shreddings to fall to the ground).
Starting the Chipper/Shredder:
• Fill with fuel and oil as directed above.
• Turn the ignition switch on the engine to the “I” or " On " position.
• Fully close the choke.
• Pull starter cord until the e n gine fires/ignites, then gradually open the choke fully.
• Allow the engine to run for 2 minutes before starting work to allow the engine to warm
up.
• Adjust the throttle as necessary.
Stopping the Chipper/Shredder:
• Reduce the engine speed by adjusting the throttle.
• Turn the ignition switch to “O” or " Off " position.