THARO H-Series Internal
Rewind Module Installation Instructions
1. Open the Top Cover of the Printer
and turn the Printer sideways.
2. Remove the 2 screws (E) for the
rewind cover and then remove the
rewind cover (C).
3. Remove the U Shape Metal Clip (2)
from the rewind shaft and then
install the Internal Rewind module
(1) using the 4 supplied screws (3).
4. After installing the Internal Rewind
Module (1), plug the cable connector
onto the rewind control socket.
5. Install ribbon and label stock in the
Printer (refer to the “Loading Media”
section in this manual).
6. Peel off several labels to expose
about 400mm (16”) of liner. Then
feed the liner between the Tear-Off
Bar and the Bottom Front Cover.
7. Wrap the liner around the Rewind
Module (1), and use the U Shape
Metal Clip (2) to secure the liner.
8. Press the Stripper Sensor (D) to flip
it open.
9. Correctly position the Sensor and
close the Top Cover of the Printer.
- 20 -
