7. Loading Media
Ribbon Out
If the ribbon runs out during a print job, the Printer will beep four times and the Red error light will
glow. An “Out of ribbon or check ribbon sensor” message will be displayed on the Printer’s front
panel. Replace the ribbon by following the instructions in this manual. Press the Feed key to
resume printing.
Ribbon Installation
1. Open the Printer’s top cover.
2. Pull the Printhead Lever out and rotate
it upward to the right
(counterclockwise) to open the
Thermal Printhead.
3. Remove the used ribbon from the
Ribbon Rewind Shaft. Remove the
empty ribbon core from the Ribbon
Supply Shaft.
4. Place the new ribbon roll onto the
Ribbon Supply Shaft.
5. Place the empty ribbon core onto the
Ribbon Rewind Shaft.
6. Feed the ribbon from the Ribbon
Supply Shaft Rod under the Printhead.
Be sure that the ribbon is not fed
under the Moveable Sensor.
- 15 -
