Thane Fitness Total Vibes, Инструкция по эксплуатации

Страница: 10 / 12

Assembly
Training
15 10
Settings
Switching the equipment on:
1. Plug the power cable into a wall socket with the
voltage corresponding to the rating label of the unit.
2.Turn the main switch to ON.
You now have a variety of setting options:
1 ON/OFF switch
2 Start/Stop
3 Time
4 Intensity
5 Program
Once you have placed the lower section on the motor
housing, place the four washers and four nuts on the
threaded rods.Turn the nuts to thread them onto the
rods.
Turn all of the nuts until they are hand tight, using an
open-end spanner.
Note:
Ensure that all of the nuts are tightened using equal
pressure, otherwise the lower section may tilt once
standing.
Now stand the equipment up, as shown in the
diagram. Insert the motor housing connector into
the corresponding socket in the lower section.
Ensure that the connector is fitted correctly into
the socket.
Turn the cable fixture in a clockwise direction to
tighten it.This will ensure that the cable cannot
come loose as a result of any vibrations.
Take the upper section in your hand and insert the
motor housing connector into the corresponding
socket in the lower section, as described above.