29
30
U
ser Manual
U
ser Manual
To remove limescale by using the cleaning pin
1. Make sure that the H2O X5® appliance is disconnected from the power
supply before maintenance.
2. Use the Cleaning Pin to remove
scale deposits from the small hole
of the steam outlet in the Main
Body, as illustrated in Fig. 2.
By swirling and pushing the pin up
and down you will clean the steam
outlet. Always ensure that all scale
debris have been removed from the
steam outlet before reassembling.
Continue swirling Cleaning Pin until
no further debris is evident.
To remove limescale by using cleaning solution
1. We recommend using the specially formulated and ready to use H2O™
Descaler by adding ½ bottle (125ml) to your water tank and filling the
remainder of the tank to the MAX indicator with tap or distilled water
Alternatively you can use a solution of 1:1 of white vinegar and water,
( ½ half white vinegar (not malt vinegar) and ½ tap or distilled water).
For best results, we recommend that you leave the solution in the tank
overnight or for at least 12 hours.
2. Secure and position the unit to ensure steam released is aimed away
from the floor or surrounding objects and surfaces. Plug the unit in,
turn the unit ON by pressing the Power Switch ( O / I ) and allow the
unit to produce steam until the descaler or vinegar/water solution is
used up.
3. Repeat the above procedure as many times as necessary until a normal
steam flow rate is achieved. Do bear in mind that the best and most
effective results will be obtained with the specially formulated
H2O™ Descaler.
4. Fill the Water Tank with fresh water and rinse out.
5. Fill the Water Tank with fresh water, switch the unit ON and release the
steam through the system until the Water Tank is empty.
2
!
WARNING
!
WARNING
NOTICE
Do not leave the steamer unattended during the lime scale removal
process and/or while in use.
Perform a test cleaning on a suitable isolated area after each lime scale
removal to ensure that there is no debris left in the system.
DANGER OF SCALDING
• Cleaning blocked H2O X5® accessories.
Due to the high mineral content of water in some areas, you may notice
that less steam comes out from the hand-held steamer accessories.
This may be caused by calcium buildup inside the tip of the nozzle.
How to clean calcium buildup:
We recommend using a spray lubricant. Spray a small burst or two of
the lubricant inside the tip of the Jet Nozzle. After spraying lubricant
inside the component, fill the H2O X5® with water according to the
directions and run a continuous jet of steam through the affected
accessory for several minutes to remove the deposit. Once the steam
pathway is clear, aim the steamer at a neutral surface or a cleaning
cloth to make sure no debris is emitted.
WE RECOMMEND PREFORMING THIS PROCEDURE IN A PROTECTED
AND WELL-VENTILATED AREA.
Steam or water discharged from the safety pressure release valve can be
very hot. At all times during use, always make sure to keep body parts
clear of the safety pressure release valve to avoid being burned by hot
steam or water in the event of discharge.
Microfiber and super absorbent cloth care:
• Machine wash at 60 ºC (140 ºF)
• Do not bleach
• Do not use fabric softener
• Wash colours separately
!
WARNING
