Connecting to Datacryptor Ethernet Units
Datacryptor Ethernet User Manual
Page 26
THALES
2.
Open a terminal session through a VT-100 terminal emulation program such as
HyperTerminal. Enter the connection name, the appropriate serial port (usually COM1 or
COM2), and the following serial port parameters:
Serial Port Parameter
Value
Baud Speed
115,200
Parity None
Data Bits
8
Stop Bits
1
Flow Control
None
3.
Switch on the Datacryptor unit.
4.
As the unit boots the message
CONFIG STARTUP Y/N
will be shown and all the units
LEDs will be lit.
5.
Press
Y
the unit will respond by displaying a short banner and the prompt IPCONFIG>.
6.
At the command prompt, type Help for a list of commands available.
Command
Description
HELP
Display help for a command
HELPKEYS
List of keyboard usage in this command interface
DEFAULT
Return all IP address and net mask settings to defaults.
DISPLAY
Display current IP address and net mask settings
IPFORWARD
Enable or disable IP forwarding
ROUTE
Add, delete, or display IP routing data
SET
Set an IP address and net mask settings
SETTIME
Display or set the unit time (Un-commissioned Datacryptor
Ethernet unit)
SHOWLOG
Basic display of log contents
VERSIONS
Display version numbers of application and bootstrap
EXIT
Exit the process and reboot the unit if a parameter has been
changed, or just exit if no changes have been made.
Note:
Before setting the Management port’s parameters, you may want to read the
IP
Management tab
section for some background knowledge on their values.
All manuals and user guides at all-guides.com
all-guides.com
