Pos. 6 Tether connection for remote control
Secure with two latches.
Pos. 7 Remote Control
Pos. 5 Throttle lever - Engine Speed Page 13
This lever regulates the speed of the diesel engine. Start the cold
engine at approximately half speed. When the operation temperature is
reached, adjust the speed to full throttle during pulling operation.
Insert remote control cable plug into connection.
Clean connections as needed and lube with dielectric grease.
To pay-out the wire rope, push the lever right while holding down the
dead-man switch on top of the lever. For pulling-in, move lever left
while holding down the dead-man switch. The amount you move the
lever increases or decreases the line speed.
When winching in, position the lever so that there is a balance
between pulling force and line speed. Otherwise, the engine may
stall.
The toggle switch on the remote control lever must always be held
on for winching in or out. Pay-out the rope the distance required, or until the
color-marked end of rope appears. Stop pulling out immediately to avoid
pulling the rope off the capstan unit.
If the Emergency-Stop is pressed (or if the set value of the measuring
system - pulling force and/or length
– are exceeded and the winching
operation is stopped automatically) this lever
must be set back to the
“Zero” position
to allow a re-start of the winching function.
