9
FIG 4.2B
Possible Extend-A-Gun RC Mounting Orientations
FIG 4.2C
Wire Clamp Locations
*** SEE FIG 4.2C ***
***FOR WIRE CLAMP LOCATIONS ***
STRAIGHT BACK
STRAIGHT BACK
REFERENCE MARK
REFERENCE MARK
(SEE FIGURE 4.2A)
(SEE FIGURE 4.2A)
MANUAL OVERRIDE
MANUAL OVERRIDE
KNOB ON
KNOB ON
EXTEND-A-GUN
EXTEND-A-GUN
INSTALL WIRE
INSTALL WIRE
CLAMPS AT
CLAMPS AT
LOCATIONS
LOCATIONS
A , B , AND C
A , B , AND C
INSTALL WIRE
INSTALL WIRE
CLAMPS AT
CLAMPS AT
LOCATIONS
LOCATIONS
A AND B
A AND B
INSTALL WIRE
INSTALL WIRE
CLAMPS AT
CLAMPS AT
LOCATION
LOCATION
A
A
NO ADDITIONAL
NO ADDITIONAL
WIRE CLAMPS
WIRE CLAMPS
NEEDED
NEEDED
The Extend-A-Gun RC manual override knob
may be mounted in any one of four possible
orientations (90 degrees apart). Install additional wire clamps
as in this Figure and FIG 4.2C. Measure 40 inches of wire between the
last wire clamp on the monitor and the wire clamp on the Extend-A-Gun RC.
Install the wire so that it winds one and a half times around the Extend-A-Gun RC Conical
Guard - WHEN EXTEND-A-GUN RC IS FULLY EXTENDED.
FACTORY INSTALLED
FACTORY INSTALLED
WIRE CLAMP
WIRE CLAMP
DO NOT REMOVE
DO NOT REMOVE
BOLT
BOLT
(TFT# VT25-20SH500)
(TFT# VT25-20SH500)
WIRE CLAMP
WIRE CLAMP
(TFT# Y4655)
(TFT# Y4655)
CLAMP LOCATION C
CLAMP LOCATION C
WIRE TO EXTEND-A-GUN RC
WIRE TO EXTEND-A-GUN RC
40 INCHES FROM LAST
40 INCHES FROM LAST
CLAMP ON MONITOR TO
CLAMP ON MONITOR TO
CLAMP ON EXTEND-A-GUN RC.
CLAMP ON EXTEND-A-GUN RC.
LOOP WIRE 1-1/2 TIMES
LOOP WIRE 1-1/2 TIMES
AROUND EXTEND-A-GUN RC's
AROUND EXTEND-A-GUN RC's
CONICAL GUARD
CONICAL GUARD WHEN FULLY
WHEN FULLY
EXTENDED.
EXTENDED.
(WIRE TFT# Y5200)
(WIRE TFT# Y5200)
CLAMP LOCATION A
CLAMP LOCATION A
STRAIGHT BACK
STRAIGHT BACK
REFERENCE MARK
REFERENCE MARK
CLAMP LOCATION B
CLAMP LOCATION B