Figure 6.2.2
Master Override Setup
6.2.2 MASTER OVERRIDE FEATURE
Any operator station with a communication board can be reconfigured with the master override feature. These stations include the
Y4E-RP, Y4E-RO, Y4E-CT-30, Y4E-CT-100, Y4E-TS, or any inputs connected to an Y4E-COMM. To enable the master override feature
on an operator station follow these steps:
1. Remove lid from enclosure.
2. Locate DIP switches on communication board.
3. Slide DIP switch #1 to the ON position.
4. Replace lid. Verify rubber seal is clean and undamaged. Verify that no wires are caught between lid and box.
6.2.3 STOW FEATURE
The STOW position needs to be programmed before use. The monitor needs to “find” two (2) hard stops, one for each axis, before the
monitor can move to the STOW position. When programming, the first two commands teach the monitor where to find the hard stops.
This insures that the position is accurate. From that point, the operator can program the move to the STOW position. During normal
operation, each time the STOW button is pressed, the monitor moves the nozzle to the full straight stream position, moves to each
programmed hard stop, and then moves to the STOW position. While the monitor is performing the STOW feature, pressing any button
will stop the monitor.
6.2.3.1 PROGRAMMING
Press & hold STOW button (~10 seconds) until LED blinks. Release button. LED will continue to blink while in program mode.
FIRST AXIS TO MOVE:
Press & release LEFT/RIGHT or UP/DOWN button of axis that will move first to hard stop. LED will blink when hard stop is reached.
SECOND AXIS TO MOVE:
Press & release LEFT/RIGHT or UP/DOWN button of axis that will move second to hard stop. LED will blink when hard stop is reached.
MOVE TO STOW POSITION:
Use LEFT/RIGHT or UP/DOWN buttons to move monitor to first point of stow routine, press & release STOW button. LED will blink
rapidly to acknowledge position.
Repeat until pattern is complete (up to 10 points).
Press & hold STOW button until LED turns off. Release button.
6.2.3.2 STOW PROGRAMMING EXAMPLE
- Press & hold STOW button until LED blinks.
- Press & release UP button, monitor will move until hard stop reached. LED blinks rapidly.
- Press & release RIGHT button, monitor will move until hard stop reached. LED blinks rapidly.
- Press LEFT button to move 45 degrees, Press & release STOW button. LED blinks rapidly.
- Press DOWN button to move 90 degrees, Press & release STOW button. LED blinks rapidly.
- Press & hold STOW button until LED turns off.
O
N
C
T
S
1
2
3
4
27
