5.6 TOGGLE SWITCH MONITOR OPERATOR STATION
This operator station allows the monitor to be controlled by three toggle switches. The installer will need to mount the operator station
and connect the cable to a primary operator station.
5.6.1 ENCLOSURE MOUNTING
Select proper operator location. Enclosure is designed to be surface mounted and the size is 5” x 3 1/8” (127 x 80mm). Height to top of
switches is 3 1/8” (80mm). Refer to Figure 5.6.1 for mounting hole dimensions.
Figure 5.6.1
Toggle Switch Operator Station
Hole Dimensions
5.7.3 CHANGING INPUTS TO ACCEPT 12 VDC
The Communication Interface Box is shipped from the
factory configured to accept ground input signals, but
can be field changed to 12 volt DC input signals.
To change the configuration:
1. Remove lid from enclosure.
2. Move MODE jumper onto both pins.
3. Replace lid. Verify rubber seal is clean and
undamaged. Verify that no wires are caught between
lid and box.
Figure 5.7.3
Communication Interface Box
MOVE JUMPER
TO BOTH PINS
22
5.6.2 ELECTRICAL WIRING
See section 5.1.2C if connecting to a primary operator station. See Section 5.9 if connecting directly to the monitor.
5.7 COMMUNICATION INTERFACE BOX
This Communication Interface Box converts discrete input signals into serial communications for controlling the monitor. The discrete
input signals can be from a joystick, toggle switches, relay contacts or Canbus output module. The interface box accepts ground
signals, but can be field changed to 12 volt signals. The installer will need to mount the interface box and connect the cable to
a primary operator station or directly to the monitor.
5.7.1 ENCLOSURE MOUNTING
Select proper enclosure location. Enclosure is designed to be surface mounted and the size is 5” x 3 1/8” (127 x 80mm). Height of
enclosure is 2 3/8” (60mm). Refer to Figure 5.6.1 for mounting hole dimensions.
5.7.2 ELECTRICAL WIRING
See section 5.1.2C if connecting to a primary operator station. See section 5.9 if connecting directly to the monitor.
