TFS NTP80plus, Справочное руководство

Страница: 26 / 57

MANUAL P/N 900000165 REV H
26
The status number has the following meaning
00,01,02,03: These are all valid. For normal operation this will be 2
04,06: indicates no time is set
08,0A: indicates there is no UTC information
0C,0E: no time and no UTC information
Where multi-constellation mode has been selected then the satellites tracked from each
constellation are identified.
The NTP status indicates the current NTP service synchronisation source and the stratum level.
For a GPS unit these would normally show GPS engine and stratum 1. For a peer-to-peer server,
the Sync Source will show the IP address of the synchronisation source and the NTP80 stratum
will be dependent on the stratum of that source. Sync source will also show the status of the
NTP service when not synchronised. These events are recorded in the event log. If the unit is in
holdover the status will state NO SYSTEM PEERS. See
Events , below, for further details.
Offset, jitter, freq offset and stability indicate the performance of the NTP service. The closer to
zero these values, the better the performance.
The page updates automatically every 10s.
The events that are shown in the status page are recorded in the event log and can be seen by
selecting EVENTS from the navigation panel.