TEXWRAP 2200SS SIDE SEAL, Руководство пользователя

Страница: 4 / 72

4
II. INSTALLATION
A. Requirements for Machine Operation
Before beginning installation the machine will need the following:
Power Requirements: 115V dedicated 20 A single-phase circuit required.
DO NOT USE AN EXTENSION CORD
Air Requirements: 12 CFM minimum at 75PSI
This must be clean, dry air.
Machine WILL NOT OPERATE properly if above requirements are not met.
B. Uncrating
Inspect the shipping box for visible damage prior to signing the freight bill. If any damage is found,
contact the carrier immediately. Do not proceed until the carrier’s agent has made an inspection of the
unit. Do not remove the machine from the shipping box.
The following steps are to be taken when removing the machine from the crate:
1)
Cut the plastic straps from the box. Use caution when doing so as the straps are under tension.
Remove all fasteners securing the box lid.
2)
Lift the box off the crate.
3)
Unbolt the lag bolts on each leg.
4)
Lift the machine off the crate. Use care not to damage any part of the machine.
5)
Adjust leveling feet for desired height of machine. Consider access between floor and frame
for maintenance personnel. 35” between floor and top of conveyor is recommended. NOTE:
Jam nuts on leveling feet must be tightened against frame or excessive machine vibration will
result. Level the machine to ensure smooth operation. Install the air filter/regulator, scrap
winder bail and the exit transfer roller assembly at this time. Untie all moving components and
remove any packing materials.
6)
Remove infeed conveyor shipping bracket.