TEXWRAP 2200SS SIDE SEAL, Руководство пользователя

Страница: 14 / 72

14
VI. ENHANCING PERFORMANCE
2200
By adjusting certain settings in the machine, the performance (measured in products per minute) can be
increased in some cases up to 15 to 20 packages per minute. The
2200 has a feature allowing an
operator to adjust all the machine settings, which maximize performance. This feature can be reached
by pressing the “MACHINE SETTING” button on the home screen, then the “MAXIMIZE
PACKAGES PER MINUTE” button. Follow the directions on screen.
All Other Models
If the forward MOTION TRIM™ percentage is set too large the machine will seal before the endseal
travels forward. This will not harm the machine, however it will reduce performance. The correct
setting for this depends on the jaw height, product spacing, bag length, and belt speed of the machine.
With each adjustment to the machine this setting may need adjustment as well. Forward MOTION
TRIM™ may also effect the length of the endseal, and if set too large, may cause the machine to act
erratically. To correct this, reduce the forward MOTION TRIM™ or increase bag length. If the return
MOTION TRIM™ percentage is set too short it is possible for the endseal to hit the package directly
behind it, therefore disturbing the spacing between the following two packages. The diagram below
shows how the MOTION TRIM™ affects the endseal cycle time. The return travel distance is
minimized, therefore increasing packages per minute. If this occurs, increase return MOTION TRIM™
until the jaws no longer hit the package.
Stroke Length
Return motion trim @ 100 percent
Forward motion trim @ 0 percent
Stroke Length
Return
motion trim @ 100 percent
Forward
motion trim @ 100 percent
Stroke Length
Return
motion trim @ 0 percent
Forward
motion trim @ 100 percent
Notice with each change the stroke length decreases, therefore increasing the packages per minute of the
machine.
Finally, to optimize the Autospace system, a few other settings may be adjusted. One being the sideseal
up time. By increasing this time, the sideseal head will not come up as quickly, therefore reducing the
start up time between staging cycles. The belt speed can also be adjusted to increase the amount of
products per minute. If the speed is set too high products may slip on the belt causing irregular spacing.