INS467-9 6/47
2.1 System Requirements
To enable all of the advanced functionality and diagnostics capability for Ricochet
V3 the following are minimum requirements:-
Wintex™ Version 6.2 Build 4 or later
Ricochet Monitor™ 0.2.18.5.1 or later
Premier Elite™ Series V4.xx or later
Premier Elite™32XP-W & 8-W Expanders V3.xx or later
N
Expander firmware version can be found on the round green sticker located on
the RH side of the PCB.
2.2 System Design Considerations
To ensure correct setup and operation of the Wireless Network it is important that
the following procedures are used when learning and placing devices.
Multiple Expander Systems
When using multiple expanders great care should be taken when designing the
system. Each expander should be treated as its own wireless network; it is not
possible for devices to hop from one wireless network to the other; it is also not
possible for expanders to pass wireless signals from devices not assigned to them
and nor can the expanders talk to each other.
Learning Devices
All devices should be learnt before they are placed in their final location. The
expander should be in commission mode, please
that they are registered on the receiver or control panel, and that Mesh Networks
and routing are established correctly. Please refer to the relevant section in this
document to Learn Devices to the system.
Learning Premier Elite SmartKey™
Premier Elite SmartKey™ should only be learned AFTER all devices and
