7 Steps to Operation
22
P5000HX(-M)-WMB Series Motherboard
Service Manual
Advanced
The options and item values for the Advanced menu are listed in the table below:
Option / Sub-Menu
Item
Default Setting
Alternate Settings
Integrated Peripherals
Serial Port A
Enabled (user configures)
Disabled (no configuration),
Auto (BIOS or OS selects),
OS Controlled (OS selects)
Serial Port A: Base I/O
Address
3F8
2F8, 3E8, 2E8
Serial Port A: Interrupt
IRQ 4
IRQ 3
Serial Port B
Enabled
Disabled, Auto, OS Controlled
Serial Port B: Base I/O
Address
2F8
3F8, 3E8, 2E8
Serial Port B: Interrupt
IRQ 3
IRQ 4
Parallel Port
Enabled
Disabled, Auto,
OS Controlled
Parallel Port: Mode
Bi-directional
EPP, ECP,
Output Only (ISA)
Note: If Mode is set to ECP, you must set the DMA.
Parallel Port: Base I/O
Address
378
278, 3BC
Parallel Port: Interrupt
IRQ 7
IRQ 5
Parallel Port: DMA
DMA 0
DMA 1, DMA 2, DMA 3
Note: This option is available only if Mode is set to ECP.
Floppy Disk Controller
Enabled
Disabled, Auto, OS Controlled
Floppy Disk Controller:
Base I/O Address
Primary
Secondary
Local Bus IDE Adapter
Both
Disabled, Primary, Secondary
Advanced Chipset
Control
DRAM Speed
70 ns
60 ns
ECC / Parity Config
Parity
Disabled, ECC
Note: The ECC option functions only if Parity/FPM SIMM’s
are installed.
Enable Memory Gap
Disabled
Hole at 512 K — 640 K,
Hole at 15 MB — 16 MB
DMA Aliasing
Enabled
Disabled
8-Bit I/O Recovery
4.5
3.5, 5.5, 6.5, 7.5, 8.5, 9.5,
10.5, 11.5
16-Bit I/O Recovery
4.5
3.5, 5.5, 6.5, 7.5
ISA Bus Speed
PCI Clock
4 (8.33 MHz with
Host Bus Speed at 66 MHz)
PCI Clock
3 (11 MHz with
Host Bus Speed at 66 MHz)
Watchdog Timer Status
Disabled
Enabled
Watchdog Timer Delay
1.2 sec
150 ms
Drive Autotype Pre-Delay
3 sec
6 sec, 9 sec, 12 sec, 15 sec,
21 sec, 30 sec, No Delay
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
