Texas Instruments DS90UB95x-Q1, Руководство пользователя

Страница: 7 / 54

3 Troubleshooting
3.1 Default Addresses
The default 9-bit I2C address of DS90UB95xis set to 0x30 (011 0000) using suitable resistor divider on ID[x] pin.
Also, 8-bit I2C address of DS90UB954 (or variant) is set to 0x7A (0111 1010) using suitable resistor dividers on
pins IDX[0] and IDX[1].
3.2 USB2ANY
The USB2ANY is required to work with any interactive GUI over I2C, such as ALP (Analog LaunchPAD).
Download and install ALP from:
http://www.ti.com/tool/ALP .
The USB2ANY is shown in Figure 3-1 . It is powered through the USB port of computer.
Figure 3-1. USB2ANY
There are two methods to use the USB2ANY to communicate with the 953/954 EVMs. The first method is to
simply connect the USB to Mini-USB cable to the USB port of your computer and the Mini-USB ports on the
EVMs, J9 for the 953 EVM (see
Figure 2-2 ) and J2 on the 954 EVM. If using the first method, skip to Section 3.3 .
The second method is to use the pinout of the USB2ANY. Figure 3-2 shows the USB2ANY pinout with the I2C
pins highlighted. Typically, jumper wires are used to connect these to the 953/954 EVMs.
www.ti.com Troubleshooting
SNLU224C – SEPTEMBER 2017 – REVISED APRIL 2021
Submit Document Feedback
DS90UB95x-Q1 Serializer Evaluation Module 7
Copyright © 2021 Texas Instruments Incorporated