170 MHz, +15 dBm
Low-Noise
Power Supply
5 VDC @ 3 A
Power
Switch
TSW14J56EVM
PC Running
HSDC Pro
Mini-USB Cable
170-MHz
Bandpass
Filter
USB 3.0 Cable
Channel A
ADC EVM
Analog Input
Low-Noise
Signal Generator
5-VDC Power Supply Cable
Low-Noise
Power Supply
5 VDC @ 3 A
www.ti.com
Quick Start Guide
2.2
Hardware Setup Procedure
A typical test setup using the ADS5XJ6XEVM and TSW14J56EVM is shown in
Figure 2
. This is the test
setup that will be used for the quick start procedure. The rest of this section will describe the hardware
setup steps.
Figure 2. Quick Start Test Setup
2.2.1
TSW14J56EVM Setup
First, setup the TSW14J56EVM with following the instructions:
1. Connect the ADS54J/58J6XEVM to the TSW14J56EVM using the FMC connectors.
2. Connect the included power supply cable to connector J11 (+5 V IN) and the other end to a
+5 VDC ±0.3 VDC, 3-A power supply.
3. Connect the included USB 3.0-to-USB 2.0 cable to the USB 3.0 connector (J9)
4. Turn on the power supply. Flip the power switch (SW6) to the “ON” position
5
SLAU641D – June 2015 – Revised January 2016
ADS5XJ6X Evaluation Module
Submit Documentation Feedback
Copyright © 2015–2016, Texas Instruments Incorporated