The software provides the sequence of operations required to complete the procedure in
order to configure the VCI.
The VCI displays the following screen during the configuration phase.
17. Follow the information that appear on screen.
18. Close the diagnostic software.
19. If connected via USB, disconnect the VCI from the display unit.
The VCI displays the following screen.
The VCI starts recording only after the diagnostic software
has been closed or after being turned off and back on.
The actual time required for the recording to start is
proportional to the number of selected parameters.
The recording mode must remain active for at least one
minute in order for the VCI to store valid diagnostic data.
III.DYNAMIC TESTS
While carrying out the dynamic tests, simply drive as usual.
You do not have to take the display unit with you.
During the dynamic tests, the only vehicle occupants must be
authorised repair technicians.
The sampling of the parameters generally takes place every second.
Any errors that may occur during the tests are stored within the memory of the VCI.
Careless driving may expose to the risk of accidents,
which may result in injuries, even serious.
Stay focused on driving.
Do not get distracted by checking the VCI
.
Do not operate theVCIin any way.
IV.ANALYSIS OF THE COLLECTED DATA
48
