• Impaq® 3000 Mk 2 Blu-ray
18
Audio settings
You can access the audio settings by pushing the button
62
“Audio Setup”.
The menus appear on the display panel. There is there-
fore no need to activate the television set or the projector.
LEVEL
– Adjust the volume of the individual speakers.
HDMI AUDIO OUT
– Activate/deactivate sound transmis-
sion at the HDMI output.
TEST TONE
– Adjust the volume of the individual speakers
with a test sound (noise).
LIPSYNC
– Set the delay of the sound output.
SURROUND
– Adjust the surround sound.
TONE
– Adjust the sound.
DISTANCE
– Set the signal travelling times of the speak-
ers.
Select the desired submenu with the navigation but-
tons
42
“
▲
” and
58
“
▼
” and push the select button
44
“Enter”.
After six seconds of keypad inactivity, the device will
return to normal mode.
LEVEL
Here you can increase or decrease the relative volume
for each speaker.
1. Select the desired speaker with the navigation buttons
42
“
▲
” and
58
“
▼
”:
FR
– Front right
SW
– Subwoofer
SL
– Rear left
SR
– Rear right
C
– Center
FL
– Front left
2. With the navigation buttons
59
“
Ï
” and
43
“
Å
”, set the
relative volume from “–10” to “+10”.
3. Finish by pushing the button
45
“Return”.
HDMI AUDIO OUT
You can switch sound transmission at the HDMI output
26
“HDMI OUT” on (“ON”) and off (“OFF”).
When you play movies, you do not need to mute the
television set in order to hear sound from the receiver
speakers.
TEST TONE
Adjusting the volume with a test tone. As described
above under “LEVEL”, you can increase or decrease the
relative volume for each speaker here. However, the
sound playback will be replaced by a test tone (noise).
The test tone is muted as soon as you leave the submenu.
58
59
62
42
43
44
45
