19
LIGHTING INSTRUCTIONS
!
WARNING
!
BEFORE LIGHTING…
Do not attempt to light the grill if odor of
gas is present.
Inspect the gas supply hose prior to turning
the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to
use. Do not use the grill if the odor of gas is
present. Only the pressure regulator and
hose assembly supplied with the unit should
be used. Never substitute regulators for
those supplied with the grill. If a replacement
is necessary, contact the factory for proper
replacement.
If the grill lid is not opened during lighting
procedures, there may be a fire or
explosion that could cause serious
property damage, bodily injury, or death.
Screw the regulator (type QCC1) onto the
tank. Leak check the hose and regulator
connections with a soap and water solution
before operating the grill
TO LIGHT THE GRILL BURNER:
Make sure all knobs are OFF; open the grill
lid and verify that the end of each burner tube
is properly located over each valve orifice.
Make sure the gas connections are securely
tightened. Open the gas supply from the LP
tank slowly until it is half open. Always keep
your face and body as far from the grill as
possible when lighting.
Your grill is equipped with a pilot flame
ignition system on the burners. Push the
Control Knob in and turn slowly (counter-
clockwise) to HI. If you have difficulty lighting
the burner, it may be necessary to turn and
hold the knob for 1 second before it “clicks”.
If the burner does not light, try once more. If
it still does not ignite, wait 5 minutes for any
accumulated gas to dissipate, and then retry.
Adjust the knobs to your desired cooking
temperature. The lowest flame setting will
occur when the knob is turned fully
counterclockwise.
TO LIGHT THE GRILL BY MATCH:
To light your gas grill by match, open the lid
and light a match. Place the lit match on the
match holder as shown in Figure A. Turn the
right main burner control knob to the HI
setting to release the gas while holding the lit
match on the match holder, located near the
main burner. The burner should light within 5
seconds. If it fails to light, turn the valve off
and wait 5 minutes before attempting to
manually light the burner again.
TO LIGHT SIDE BURNER
To light the side burner, remove any cooking
utensils from the burner grate. The Side
Burner utilizes the same ignition system as
the grill burners. Please use the same
procedure described above in “TO LIGHT
THE GRILL BURNER” for the Side Burner. If
it is necessary to utilize a match to light the
Side Burner, utilize instructions “TO LIGHT
THE GRILL BY MATCH” above.
TO LIGHT REAR BURNER
Open the lid. Before lighting Rear Burner,
remove Warming Rack as heat from rear
burner may damage it
. Turn the Rear
Burner control knob to HI. While holding in
the knob, push the Electronic Rear Burner
Ignitor to light the Rear Burner. Once the
Rear Burner is lit, continue to hold in for
another 15 seconds to be sure the burner
stay lit. If the burner does not light, turn the
Control Knob to “OFF”. If the ignitor does not
function, follow the instruction above for
match lighting
.
WARNING: ALWAYS KEEP YOUR FACE
AND BODY AS FAR FROM BURNERS AS
POSSIBLE WHEN LIGHTING.
