30
- Key Board Control Code Screen
When you want to know the input signal of an exterior controller,
you can see the input data by connecting the communications cable
to the RX terminal of the Rapport 337.
•
How To Control PTZ
PTZ functions (controlling Up, Down, Left, Right), etc. are possible to be
tested, by using buttons : FAR/NEAR(FOCUS ADJUSTING), TELE/
WIDE(ZOOM ADJUSTING), and SHIFT SETUP.
•
FUNCTION SETUP of PTZ
By using the SHIFT SETUP key, adjust GPST / SPST / TOUR /
SPD / MENU displayed on the lower part of LCD screen by pressing SET
key once shortly.
GPST : It moves the camera view to the designated preset location.
Setup can be from 1 up to 99. (short for GO TO PRESET).
When the cursor runs to GPST position after key is pressed,
select the previously memorized PRESET number, using number,
using & keys. When the selection is completed, press
key one more time, it moves to the memorized location.
29
- The controlling code of protocol
from the key board or DVR is
displayed on the screen.
Most important, however, is that the
communications speed should be of
one accord.
SPST : It memorizes PRESET. Setup can range from 1 up to 99. (short
f o r SET PRESET).
First, move the camera to the view to be designated , and press
key, and using & keys, place the cursor at the
location of SPST. Then, set up the address that you want to
memorize by using & keys, and then, press key
one more time. The information of location is stored in SPST
adress.
TOUR : It operates TOUR set up at SPST and MENU. Setup can be from
1 up to 99. TOUR can be designated in the MENU of PTZ.
SPD : Place the cursor at the location of SPD, applying the procedures
described above. Total 16 steps(from 1 to 16) of speed are
available to be selected using & keys.
MENU : Place the cursor at the location of MENU, applying the procedures
described above. The MENU of PTZ itself is available to be
displayed on LCD screen. using key.
C A U T I O N
•
Make sure to check for communications protocol, transmission
speed, and ID.
