User Manual for Tersus GeoBee30 v1.0
10
Note:
1) There are two configuration modes for GeoBee30. GeoBee30 system is zero configuration
if customer adopts GeoCaster provided by Tersus GNSS Inc., as GeoBee30 is
pre-configured when shipped out of factory. GeoBee30 system needs to be configured if
customers demand to set up caster by themselves.
2) David30 GNSS receiver uploads RTCM stream to the NTRIP caster using Ethernet (default) or
Wi-Fi or 2G/3G/4G sorted by priority.
a. When using Ethernet to configure TR600, use Ethernet cable to connect the LAN2 port of
TR600 to your computer, connect LAN1/WAN port to a router to access internet. Make
sure the IP address of your computer is set as “Obtain an IP address automatically”. Type
192.168.100.1
in your browser, use username “
root
” and “
1234
” to enter web config page,
make sure the DHCP is on in LAN setting so that TR600 can automatically obtain an IP
address.
b. When using Wi-Fi to configure TR600, search SSID “TR-600” on your computer and
connect it use password
12345678
. Type
192.168.100.1
in the browser of your
computer or mobile phone or tablet, use username “
root
” and “
1234
” to enter web
config page.
Please note, both Wi-Fi client and Wi-Fi hotspot of Ntrip Modem TR600 are
supported, however they cannot be enabled simultaneously.
Wi-Fi hotspot
function is to share internet connection to other devices or configure TR600 via Wi-Fi.
Wi-Fi client function is to use Wi-Fi connection to communicate with caster when
Ethernet connection is not available.
When using Wi-Fi to communicate with caster, choose Wi-Fi Client to access internet
in Network Settings of TR600. Select a SSID to be used and type the Wi-Fi password
in the PSK pin area, click [Save] to save this setting.
