TerraTec PHASE 26 USB, Руководство пользователя

Страница: 8 / 48

registers on the system, it informs the operating system of its specific properties for the
mode in which it is operating. The operating system then configures the hardware
accordingly and prompts for the drivers necessary for the new installation. In other words,
modes 1 to 4 plus the ASIO mode appear as 5 different physical devices to the operating
system, where each mode requires its own separate drivers to be installed.
The individual operating modes.
Depending on how you want to use the PHASE 26, change the operating mode using the
switches on its front panel. The individual modes available to you are:
Mode Audio inputs Audio outputs Max. resolution
1 1+2 - 24/96
2 - 1+2 24/96
3 1+2 1+2 24/48
4 1+2 1-6 16/48
If ASIO is enabled on the system, the four operating modes can be switched likewise. As
such, the module is then set up in all common audio applications as an ASIO device with
very low latency and the best possible sound quality. For “non-ASIO” audio applications,
however, you will have to do without the ASIO modes.
Note: As long as a software application is accessing a PHASE 26
USB driver, the device modes are locked and cannot be switched.
The PHASE 26 USB ControlPanel, too, blocks the device from
being switched and has to be closed in order to switch modes.
The input switch does not have any effect on driver selection. This is described further on
in section “Analog inputs.”,
Ü
page 22.
8 PHASE 26 USB (English)