TerraKing 45-0592, Руководство оператора

Страница: 6 / 28

6
Install Handle
1. Locate handle and hardware inside the parts bag
2. Attach handle to outside of Auger tray with the bolts
inserted from the inside and flange nuts on the outside as
shown in Figure 1
3. Tighten hardware using ½” wrench or socket
Install Display and Wiring
Mount display in a location that is convenient for the
operator using either the included bracket, p-clamps or
M5 screws and washers.
Starting at the battery, connect the ring terminals on
the battery harness to the battery (red positive, black
negative). Connect extension harness to the battery
harness and route the extension harness towards the
3 point hitch or 2” receiver securing the harness to the
vehicle along the way. ensure the harness does not
contact any moving or high temperature components.
Secure the connector on the free end of the extension
harness in the convenient location that is easily accessible
in order to connect/disconnect the spreader. Coil any extra
harness and secure with wire ties.
Connect the circular connector on the display harness to
the rear of the display. Hand tighten until is fully seated.
DO NOT over tighten/ DO NOT cross thread. Route the
display harness to the same location as the free end of
the extension harness. Coil any extra harness and secure
with wire ties.
Installing
Locate a 12V signal / circuit that is behind the key switch
(only powered when the key is turn to run or acc). Route
the single wire in the display harness to this location and
secure to the vehicle along the way with wire ties. Extra
harness can be removed or coiled and secured with
wire ties. Connect the single wire to the circuit using a
suitable connection. A wire splice is included in the kit for
convenience.
Mount Spreader to Vehicle
Mount the spreader to the 3 point hitch or 2” receiver.
Use the handles located on the hopper side panels to lift
into position and secure in place. It is recommended that
2 people lift the spreader into place.
Connect the 2 connectors on the harness attached to the
spreader to the free end of the extension harness and
display harness.