TerraKing 45-0592, Руководство оператора

Страница: 9 / 28

9
Display Screen Messages
During operation a message may appear describing a
potential issue or problem.
Motor Over Current A motor is drawing too
much current. Spreader will
shut down, display an error
message, and prompt the
operator to reset the spreader.
The spinner disk may be
jammed and needs to be
cleared.
Motor Open Circuit This message is displayed
when a motor is disconnected.
Ensure that all harnesses
are installed correctly, and
connectors are fully seated.
Ensure that the status light on
the motor controller is green.
Voltage High This message is displayed
when the controller is receiving
a voltage higher than 16V.
Please check battery voltage.
Voltage low This message is displayed
when the controller is receiving
a voltage lower than 9V. Please
check battery voltage.
No Comm This message is displayed
when there is a loss of
communication with the
motor controller. Ensure that
all harnesses are installed
correctly, and connectors
are fully seated. Ensure that
the status light on the motor
controller is green.
Spreading
NOTE: Always use the hopper cover to prevent moisture
buildup. Do not let spreader sit idle with material in the
hopper for an extended period of time. This can cause
material to compact, reduce or stop the flow of material and
cause permanent hopper damage.
CAUTION: DO NOT leave unused material
in hopper. Material can freeze or solidify,
causing unit to not work properly. Empty
and clean after each use.
IMPORTANT: Never operate near pedestrians.
Never exceed 10 mph while spreading. This
spreader is for rock salt, ice melt, fertilizer or
lime only.
CAUTION: Disconnect electric and/or
hydraulic power and tag out if required
before servicing or performing maintenance.
Settings Menu
Selecting settings from the main menu will enter the
settings menu.
From the settings menu, the user can select the following:
•
Display to select the brightness level.
•
CAN, to enable/disable the CAN terminator resistor.
•
Exit, go back to main menu.
Operation