Termo 562100, Инструкция по эксплуатации

Страница: 12 / 33

GB INSTRUCTION MANUAL
22
G. Serious pitch and pump, excessive slope will cause operation problems,
e.g. operating noise will become higher. Residual water in unit may also run
over under the excessive slope.
H. Store:
a. The machines should be empty tank water when not in use
and unplug the power.
b. Roll up the power cord.
c. Clear air filter
d. Store in dry and clear environment.
CARE AND MAINTENANCE
B. Check the Drainage Water Pipe :
It is necessary to keep the water pipe unobstructed to drain the water
smoothly and make the unit work normally. You should check the
water pipe regularly and replace it if necessary.
C. Don’t use the unit near heat producer like stove, heater or cold air
influence dehumidifying effect or cause danger.
D. Don’t put the unit at the place where it may be splashed lest it
causes electrical leaks.
E. Unit should be safely placed before operated, make sure it will not
overset and cause danger.
F. Pay attention to the room humidity level if the room is decorated
with wooden furniture or other woodwork, for exceeding dryness will
result wood cracking.
The crossed-out wheeled bin symbol indicates that the item should be disposed
of separately from household waste. The item should be handed in for recycling in
accordance with local environmental regulations for waste disposal. By sepa-
rating a marked item from household waste, you will help reduce the volume of
waste sent to incinerators or land-fill and minimize any potential negative impact
on human health and the environment.
23
GB INSTRUCTION MANUAL
Please try the suggestions below to see whether you can solve the problem without
outside help.
PROBLEM
Unit does not operate
Dehumidifying capacity
(water removal) is low
Relative humidity setting
not reached after long
period of operation.
Water on floor
Outlet air is warm.
Water noise
El error
LO error
POSSIBLE CAUSE
Unit power cord is umplugged.
Unit has of been turned on.
Light is too short.
Runtime is too short.
Air filter is firty and/or
obstructed.
Ambient room temperature is too
low or humidity too low.
Setting humidity is higher
than the ambient humidity.
Drainage water pipe is
blocked or flat.
Doors and windows are not closed
or sealing capacity of ambient room
is not good.
Unit is lurched too much by moving;
residual water in unit.
Heat exchanging processes.
Refrigerating fluid flows.
Humidity Sensor is broken or
damped.
Ambient humidity is lower than 35%.
SOLUTION
Pull the plug and connect it
again or please check if there are
power in the outler.
Turn on the switch.
Water tank is full, empty the
tank; make sure the tank is in
the right place; the float flops,
relocate it.
waiting.
Use water to clean the filter.
Dehumidifying capacity is
normally lower if the room
temperature is below 18 V .
Please try to increase the room
temperature.
Setting the humidity down
and lower than the ambient
humidity.
Check the water pipe and repla-
ce it if necessary.
Close the door and windows or
enclose the space.
Normal phenomenon
Normal phenomenon
Normal phenomenon
Replace it.
It don’t need dehumidification,
because of low humidity.
TROUBLE SHOOTING TIPS