Terex Genie Z-60 DC, Руководство по обслуживанию

Страница: 134 / 193

Service and Repair Manual August 2022
Drive Control Fault Codes
122 Z ® -60 DC • Z ® -60 FE Part No. 1307785GT
CAN
Object
Flash
Pattern
Description & Fault
Type
Cause Effect Solution
2632 10-8
Driver Assignment
Fault Type(s): 5
{X} = Driver number
that cause the fault
A Driver Output is used for
two or more functions
See Programmer »
Controller Setup »IO
Assignments » Coil Drivers:
Main Contactor Driver,
EM Brake Driver,
Hydraulic Contactor Driver
Fault Action:
None, unless a fault
action is programmed in
VCL
Set: Driver assignment
conflict (i.e., duplicate items
assigned to the same driver)
Clear: Resolve the
conflicted driver assignment,
then Reset Controller
2169 10-9
Coil Supply Fault
Fault Type(s):
1 = short to B- or HW
fault
2 = Coil Supply
disabled due to
shorted (internal)
driver.*
3 = Coil Supply
startup enable check
failed
4 = Coil Supply
startup disable check
failed
*a short must first be
detected
1. Short on driver loads
2. Dirty connector pins at
controller or device
3. Bad connector crimps or
faulty wiring
4. Controller is defective
ShutdownAll:
ShutdownMotor
ShutdownMainContactor
ShutdownEMBrake
ShutdownThrottle
ShutdownInterlock
ShutdownDriver1 to 7
ShutdownPD
FullBrake
ShutdownPump
ShutdownCoilSupply
ShutdownVehicle
ShutdownLower
ShutdownLift
Set: Short detected after the
startup check has passed
A low side driver short is
detected and the respective
fault action fails to cut-off
driver current
Coil supply startup test fails
Clear:
Reset Controller
2620 11-1
Analog 1 Out of
Range
Fault Type(s):
1 = above High limit
2 = below Low limit
1. Analog 1 input voltage is
above the parameter setting
of Analog 1 High
2. Analog 1 input voltage is
below the parameter setting
of Analog 1 Low
See Programmer »
Controller Setup » Analog
Inputs » Analog 1
See Programmer »
Controller Setup » Analog
Inputs » Configure » Analog
1 Low / Analog 1 High
Fault Action:
None, unless a fault
action is programmed in
VCL
Set:
(1) Input voltage (on pin) is
above the parameter’s set-
point threshold
(2) Input voltage (on pin) is
below the parameter’s set-
point threshold
Clear: Return the voltage to
within the allowed range,
then Reset Controller
2621 11-2 See Analog 1 Out of
Range
See Analog 1 Out of Range
See Analog 1 Out of
Range
See Analog 1 Out of Range
2622 11-3 See Analog 1 Out of
Range
See Analog 1 Out of Range
See Analog 1 Out of
Range
See Analog 1 Out of Range
2623 11-4 See Analog 1 Out of
Range
See Analog 1 Out of Range
See Analog 1 Out of
Range
See Analog 1 Out of Range