Terex Genie Z-30N, Руководство оператора

Страница: 33 / 59

Seventh Edition • First Printing Operator's Manual
Inspections
Part No. 1297932GT Z
®
-30/20N • Z
®
-30/20N RJ 31
54 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
55 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
56 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
57 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
58 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
59 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
60 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
61 Retract the primary boom to the stowed
position.
Result: The machine should drive.
62 Return to level ground and stow the boom.
63 With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
64 Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
65 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
66 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.