Terex Genie GRC-12, Руководство по обслуживанию

Страница: 77 / 135

February 2022 Service Manual
Mast Components
Part No. 1314708GT GRC ™ 65
5 Attach a lifting strap from an overhead
supporting device to the number 2 mast and
carefully slide the number 2 mast onto the
number 1 mast, with the cylinder mount
brackets facing the work table.
Crushing hazard. The mast
section could become
unbalanced and fall if not
properly supported.
Note: During installation, the lifting strap will need
to be adjusted for proper balancing.
6 Slide the lower, inner corner wear pads
between the number 2 mast and the number
1 mast. Align the holes on the wear pads to
the rivet holes on the lower half of the number
2 mast and secure into place using the
appropriate rivets.
Illustration 2
1 mast number 2
2 rivet
3 wear pads
4 mast number 1
7 Slide the number 2 mast towards the bottom
of the number 1 mast and align the lower
number 2 mast access holes to the lower
number 1 rivet holes. Refer to Illustration 3.
8 Working at the top of the number 2 mast,
carefully slide the lower corner wear pads
between the number 2 mast and the number
1 mast. Refer to Illustration 3.
9 Align the rivet holes on the wear pads to the
number 2 mast access holes and to the
number 1 mast rivet holes. Refer to Illustration
3.
10 Using the appropriate rivets, install the lower
corner wear pads, to the lower half of the
number 1 mast. Refer to Illustration 3.
Illustration 3
1 wear pads
2 rivet
3 mast number 1
4 mast number 2