8.4
Network Setup page
The Network parameters are set on this page. The following parameters can be changed:
•
IP configuration
– IP Address configuration can be static or dynamic (DHCP)
•
IP address, Subnet mask , Default gateway –
these fields are active if IP address is
static
•
Host Name
•
MAC –
device MAC address
If multiply
TCW180
controllers are used on the same network, please change the IP address
after connecting the device to the network. This will avoid devices installed on the network with
the same factory default IP address at the same time. It may be necessary to clear the arp cache
each time you connect new device to the network. This is done by typing
arp -d
in the command
prompt of a Windows computer.
In order to reduce network traffic and to limit the access, the controller supports VLAN and
MAC address filtering. In addition to the MAC address of the Default Gateway, another 2 MAC
addresses can be added to the filter. The filter is enabled by marking the appropriate check box
after the MAC address.
To set up the SMTP server the following fields should be completed:
•
Mailserver [IP:port] –
IP address and port number of SMTP mail server
•
E-mail –
sender mail
•
Username&Password –
these fields are required
if using SMTP server with authentication
