IB 340857 (03--2007)
3
6. Use three hex screws (6) and three flat
washers (7) to install the bracket (5) onto the
back of the machine. Refer to Fig. 6.
5
6
7
FIG. 6
7. Use a hex screw (6) and flat washer (7) to
install the cable clamp (9) on the warning/
backup harness (8) onto light support bracket
(5) and solution tank. Refer to Fig. 7.
5
6
7
9
FIG. 7
8. Connect the wires from the backup alarm (1)
and the strobe light (13) to the warning/
backup harness (8). Refer to Fig. 4.
9. Route excess cable from the main wire
harness and the warning/backup harness (8)
back down between the recovery and solution
tank. Refer to Fig. 3 and Fig. 4.
10. Reconnect the positive terminal and then the
negative terminal to the battery.
11. Start the machine and move the machine in
reverse. The backup alarm should sound
while machine is moving in reverse. The light
should function while the engine is operating.
