IB 340857 (03--2007)
7
5. Insert a grommet (10) into the rear hole in the
rear cross member of the overhead guard and
route the warning/overhead harness (9)
through the grommet and the front hole in
the rear cross member. Refer to Fig. 5.
10
Install first, before
routing warning/
overhead harness
(9) through cross
member
Install after routing warning/
overhead harness (9)
through cross member
10
FIG. 5
6. Slide the remaining grommet (10) onto the
warning/overhead harness (9) and insert the
grommet into the front hole in the rear cross
member of the overhead guard. Refer to Fig. 5.
7. Route the warning/OHG harness (9) through
the notch in the overhead guard insulation
and connect the harness to the strobe light
(13). Refer to Fig. 6 and Fig. 10.
FIG. 6
8. Use four cable ties (12) to secure the warning/
overhead harness (9) to the leg of the
overhead guard. Refer to Fig. 7 and Fig. 8.
FIG. 7
FIG. 8
9. Use two cable ties (11) to secure the warning/
overhead harness (9) to the top of the
overhead guard. Refer to Fig. 12.
10. Use two hex screws (2), two flat washers (3),
and two hex nuts (4) to install the backup
alarm (1) onto the bracket (5). Refer to Fig. 9.
1
2
3
4
5
FIG. 9
