IB 340857 (03--2007)
2
2. Route the wires from the strobe light (13)
down through the hole in the light support
bracket (5) and use a hex screw (2), flat
washer (3), and hex nut (4) to install the light
onto the bracket. Refer to Fig. 2.
13
2
3
4
5
FIG. 2
3. Route the wires from the strobe light (13)
through a cable clamp (9) and use a hex
screw (2), two flat washers (3), and hex nut
(4) to install the cable clamp underneath the
lamp support bracket (5) and completely
secure the light to the bracket. Refer to Fig. 3.
13
2
3
4
5
3
14
FIG. 3
4. Open the recovery tank cover and pull the
main wire harness backup alarm and
revolving light connector from between the
recovery and solution tank. Connect the
warning/backup harness (8) to the main wire
harness. Refer to Fig. 4 or Fig. 5, and Fig. 8.
FIG. 4 -- M20 Harness Location
FIG. 5 -- T20 Harness Location
5. Route the warning/backup harness (8)
through the notch in the solution tank and
install a cable clamp (9) onto the harness.
Refer to Fig. 8.
