ENGLISH
EN
5100 (02–01)
5
MACHINE INSTALLATION
UNCRATING MACHINE
Carefully check carton for signs of damage. Report
any damage at once to carrier.
To uncrate your machine, remove shipping straps and
carefully lift or make a ramp to remove machine from
pallet.
Raise scrub head to transport position before
maneuvering machine. Step down firmly on scrub
head lift pedal to raise (Figure 1).
NOTE: To prevent scrub head skirt damage, always
keep machine in transport position when pad driver is
not installed.
FIG. 1
ATTENTION: Do not roll machine off pallet,
damage may occur.
Squeegee assembly is packaged with machine.
Batteries, battery charger, brush, pad driver and pads
must be purchased separately.
ATTENTION: Battery installation must be
accomplished AFTER removing machine from
shipping pallet.
INSTALLING BATTERIES
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective gloves when handling batteries or
battery cables. Avoid contact with battery acid.
Battery Specifications:
Two 12 volt, deep cycle batteries. Consult with an
Authorized Distributor for specific batteries. Maximum
battery dimensions are 17.8cm(7 in) W x 33cm(13 in)
L x 25.4cm(10 in) H.
1.
Park machine on a level surface and turn off all
switches and remove key.
2. Remove battery hood to access battery
compartment. Then remove metal battery tray and
loose battery cable from compartment.
3.
Disconnect vacuum hose from recovery tank
snout. Carefully install bottom battery into
compartment with battery posts positioned
towards rear of machine (Figure 2).
FIG. 2
ATTENTION: Do not drop battery into
compartment, battery and machine housing
damage may result. This damage is not covered
by warranty.
4.
Connect red battery cable coming from machine to
positive (+) post of bottom battery. Then connect
black jumper cable to negative (–) post (Figure 4).
5.
After connecting cables to bottom battery, carefully
hang metal battery tray on studs located above
bottom battery. Place top battery into tray with
posts positioned towards rear of machine. Secure
top battery with strap (Figure 3).
FIG. 3
