EN
ENGLISH
12
5100 (02–01)
ADJUSTING SQUEEGEE LIFT CABLE
To adjust squeegee lift cable, loosen lock nuts and
turn adjustment stem on squeegee cable. Retighten
lock nuts after adjusting (Figure 30).
FIG. 30
DRAINING TANKS
When finished scrubbing, or when solution flow stops,
or when float shut–off screen is activated, or squeegee
starts trailing water during operation, the recovery tank
should be drained.
Always drain tanks and rinse recovery tank with clean
water after each use. If you used the ES
t
recycling
system, be certain to drain and rinse solution tank,
also.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
DRAINING RECOVERY TANK
ATTENTION: Drain recovery tank when refilling
solution tank. Foam or water may enter float
shut–off screen and damage vacuum motor.
Vacuum motor damage due to foam or water is
not covered by warranty.
1.
Push machine to floor drain and turn off all
switches. Remove left side drain hose from holder,
position hose over drain and twist loose and
remove drain hose plug
(Figure 31).
FIG. 31
NOTE: If using a bucket to drain machine, do not use
same bucket for filling, or be certain to rinse it out
before refilling machine.
2.
Open clear recovery tank lid and rinse tank, ball
float screen and ES
t
filter if equipped. Remove
and rinse float shut–off screen and ES
t
filter if
they are excessively dirty. Replace screen and
filter securely.
3.
Replace drain hose plug securely when empty.
DRAINING SOLUTION TANK
To drain unused cleaning solution or recycled solution
from solution tank, follow steps below:
1.
Remove clear drain hose from hose barb, position
hose over drain (Figure 32).
FIG. 32
2.
Rinse out solution tank and solution flow system
with clean water to prevent clogging due to
chemical buildup.
3.
Replace drain hose securely on hose barb when
empty.
